1、当首次运行ocfs2console时,提示如下:run "/etc/init.d/o2cb enable" ,请问这个命令是否需要手工运行?因为# /etc/init.d/o2cb configure命令已经配置了Load O2CB driver on boot。
# /etc/init.d/o2cb configure
Load O2CB driver on boot (y/n) [y]: y
Cluster to start on boot (Enter "none" to clear) [ocfs2]:
Specify heartbeat dead threshold (>=7) [7]: 61心跳死亡阈值设置多大合适?
Writing O2CB configuration: OK
Loading module "configfs": OK
Mounting configfs filesystem at /config: OK
Loading module "ocfs2_nodemanager": OK
Loading module "ocfs2_dlm": OK
Loading module "ocfs2_dlmfs": OK
Mounting ocfs2_dlmfs filesystem at /dlm: OK
Starting O2CB cluster ocfs2: OK
[ 本帖最后由 test5008 于 2009-2-9 14:26 编辑 ]