1.An Ethernet media trunk link is to be conflgured between two Cisco switches,each
having identical modules.software revisions and VLAN configuration information. Which
two are REQUIRED for the trunk to operate?(choose two)
A. The link is 100 Mb/s or slower
B. The link uses 802 1Q trunk protocol
C. The link must be point-to-point if it is ISL
D. The link must have different trunk encapsulation at each end.
E. The link may use 802.10 trunk protocol,providing the SAID parameter is correctiy set.
Answer:C E(b,e) (B,E)?
2.An Ethemet media trunk link is to be configured to operate in ISL mode between two
Cisco switches, each having identical modules, software revisions and VLAN
configuration information, Which two are NOT required for the trunk to operate in ISL
mode correctly?(choose two)
A. identical speed at each end of the link
B. identical duplex at each end of the link
C. identical native VLAN parameter at each end of the link
D. identical trunk negotiation parameter at each end of the link
E. identical trunk encapsulation parameter at each end of the link
F. compatible trunking mode shared by the ports connecting the link at either end
Answer: D F(c,d) (C,D)?
3.Which two steps are used to explicitly configure the operation of a Fast Ethernet
connection between the distribution and core layer switches? (Choose two.)
A. assign an IP address to the core switch
B. create a port description for the FE module/port on the distribution switch
C. set the port duplex description for the FE connection between the distribution and core
switches
D. set the port speed description for the FE connection between the primary' distribution
switch and the core switch
Answer: A B? |